Pockels cell driver

wiki: Pockel cell basdard configuration

Current Engineering GUI

Pockels_cell.png

Firmware and Driver Notes

To run the firmware, you will need an Arduino Uno with ethernet shield and the latest IDE. No SD card this time. The attached document describes how to configure the ethernet interface, the protocol and how to use the test commands. In the eth_heater file you'll find working C code for the CRC. Our mirror heater at LBT uses the same protocol.

LabView Engineering GUI

Snapshot of the Labview engineering GUI from Julian

pcd01_150611.jpg

Topic revision: r3 - 01 Aug 2018, AndrewColson
This site is powered by FoswikiCopyright © by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding Foswiki? Send feedback