LAT mounting

Electronic cabinet installed. LAT put on the telescope but could not be finally mounted. Upper taps for screws didn't fit. Lower ones are a bit to low either. Couldn't get properly behind the alignment bar. Therefore, the bar was adapted at the spot to fit the LAT base plate properly behind.

Vibration system geometry measurement

Installed telescope to measure the LM1 geometry. Couldn't open the shutter as pressed air was off.



-- WolfgangGaessler - 11 Oct 2015
Topic revision: r1 - 11 Oct 2015, WolfgangGaessler
This site is powered by FoswikiCopyright © by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding Foswiki? Send feedback